CD Mastidek Fast Outdoor Cartridge Glue Standard Cream (Taga, Arga, Iron, Danae, Sasea, Quatar, Sarey, Makai, Gada, Edora, Blanc Concrete) 215 ml

For use with Dekton Taga, Arga, Irok, Danae, Sasea, Quatar, Sarey, Makai, Gada, Edora, Blanc Concrete.
Formerly Danae.

Mastidek Cartridge Glue for Cosentino Dekton is a new generation bi-component resin used to glue Dekton. Dekton Mastidek Fast Outdoor Cartridge glue has a very high adhesion in a short amount of time which allows for cutting and polishing the assembled parts in a short time…approximately 45-60 minutes. The hardened product is very shiny and is very polishable.

This product is produced in special cartridges with a 2:1 bi-axial quantity 215 ml. The glue and hardener are pre-dosed in the cartridge which, once inserted in the proper gun, with the special mixer fixed on top, allows the correct extrusion and mixing of the product. Requires use of special M200XMR Cartridge Gun. Suitable for outdoors.

DIRECTIONS FOR USE:

All surfaces must be cleaned and free of dust and grease. When applying to a polished or glossy surface it is advised to scrub the surface with sandpaper before gluing. Remove cap and attach the special threaded mixing nozzle. Squeeze out about 6″ of product before applying to surface. Clean the nozzle after use, replace the cap and discard the mixing nozzle. Repeat this process at any change of mixer. After usage, clean the nozzle, replace the cap and discard the mixer after. Product will not set below 32.

SHELF LIFE:

The product in the cartridge will last at least 12 months if stored between 65 and 77. Keep away from sunlight, heat and humidity.

SAFETY:

Please read the safety data sheet before use and follow the product instructions.

• Gel time in bulk at 77: 2-5 min
• Tacky free time at 77: approx. 15 min
• Working time at 77: 45-60 min
• Temp range for use after hardening: -13 to 140

Typical Technical Data Viscosity cps 25C 20 r.p.m.(ASTM D2196) Tixotropic Liquid Density at 25C gr/cm 3 1.27 Aspect Colored Liquid Ratio of use glue/hardener 100+50 Gel time (in bulk) at 25 C in min 2min-5min Time for handling pieces Approximately 15 min Working time suggessted at 25c in min Approx 45-60 min Minimum reaction temperature +1C Minimum temperature of use after hardening -25C Maximum temperature of use after hardening +60C Shelf life at 25C for the WA version 12 months Adhesion Force in MPa at 25C on DEKTON, diamond cut surface after 1 hour (ASTM D 4541) 11.0 Adhesion Force in MPa at 25C on DEKTON, diamond cut surface after 30 days (ASTM D 4541) 12.9